Seattle · Sub-Zero
Wine Cooler Repair for Sub-Zero Wine Storage
Wine storage gets noticed late, because nobody checks a bottle until they open it. The calls start with a zone that reads a few degrees high, fog inside the glass, or a hum from the kitchen after the house has gone quiet.
What we usually find
What we usually find is a question of air. A fan that has slowed or stopped, a condenser clogged with dust at the toe kick, bottles packed against the vent at the back of a zone. Compressor faults happen, and we check for them properly, but on a cabinet that still cools part of the time they are rarely where the fault is.
What it costs
What wine cooler repair costs
These are the bands a Sub-Zero repair falls into here, parts and labor together. The low end is an easy part in a reachable spot; the high end is the same part buried behind panels, or on a model whose parts cost more.
One flat $89 pays for the visit and the complete diagnosis; approve the repair and those $89 are deducted from its price.
- Door gasket or seal replacement
- $290–$640
- Evaporator or condenser fan motor
- $330–$690
- Defrost heater, thermostat or sensor
- $260–$690
- Ice maker, water valve or supply line
- $270–$750
- Electronic control board
- $420–$920
- Compressor or sealed-system repair
- $1,410–$3,350
The band tells you roughly where you stand before the visit. The firm number comes once the cause is proven, written down before any panel is removed, and the $89 visit fee is deducted from it when you give the go-ahead. Work with no band of its own is priced after the diagnosis, never guessed at.
Customer reviews
What Seattle owners say
Built-in Sub-Zero calls in Queen Anne, Madison Park, Laurelhurst and Magnolia.
4.9/ 51,555 reviews
The lower zone would not come down below the mid fifties whatever I set. He found a refrigerant restriction and was straight that it meant sealed-system work rather than a quick part. Steady for a month.
Hamish L.Laurelhurst
Top zone sat six degrees warmer than the display claimed, which for reds matters. The damper motor had stalled, and he verified that with his own probes rather than the readout.
Beatrix N.Queen Anne
Interior light flickered and the temperature alarm tripped at random, so I expected a new board. It was a chafed harness behind the kick plate. Repaired, re-routed, and he shimmed the cabinet so it cannot rub.
Isolde W.Magnolia
Cabinet running warm?
Ring before the food decides for you
Give the model number and what the cabinet is doing, and the visit is booked from there. Visits 8:00 am – 8:00 pm, seven days; a person answers the phone 24/7.